Exchange of evaporative air conditioning reverse cycle (HVAC) Air Conditioning - A Complete Guide

Often people want to know if they change their existing stores to an exhaust system evaporator ducted reverse cycle again (HVAC), Air conditioning, all with the same pipes e. The simple answer is no. The following is a list of reasons why you can not just change the system through a reverse circulation (HVAC).

First, the grid of reverse circulation (or branches) generally applied around windows and doors from a distance. This allows the airCondition of heat / cold that goes directly through the windows. The air flow in a reverse cycle should also have the longest way home from the socket, the front grille. If a socket has been placed near a door, window air would simply be sucked back under the door in the direction of the return air grille and the surrounding area are hot spots.

Air

The problem with the pan evaporation is that they are generally removed from the door. Evaporative emissionsUnit air flow should preferably take place along the way to the room and out the window. If they are, are right next to a window, the air would flow from the premises caused hot spots would be only the window and close the doors and in others.

For these reasons, it is not advisable to reverse the cycle grating at the same point where a network ducted evaporative emissions was the first judge. Even if you do, it will be hard, affecting the efficiency and capacity ofthe system. The best option is to restart and the new reverse cycle grid in the desired correct position as required. However, this would mean that you would need to patch and paint holes in the ceiling by removing old and evaporation of the grid that can be left to an expensive task.

Another option would be to add an extra grill if needed. You can control the grid near the doors of the evaporator system and add additional screens on the windows when necessary.

AnotherProblem between the systems is over, the old pipes can not be used. The units of deductions for evaporative emissions is far greater than that required for reverse cycle ducted air conditioning air. Evaporative units in service around the thumb mark system of channels 16-20. This channel is formed by the evaporative cooling air conditioner when the air is extremely quick shots, and it will take hours in the air at the peak of 40 times the cubic room of the house. Reverse cyclecanal system is usually only the mark of 12 inches in diameter. This is because the air conditioning reverse cycle is much slower than the equivalent of evaporative cooling.

evaporation tube is usually only slightly, if at all isolated. Reverse cycle piping should always be isolated at least 2 cm, to take to avoid the heating / cooling and condensation.

So if your current evaporator system to a new round of reverse air-swapSystem, it is better to start all over again. Make sure you get some offers for the cost of patch and paint the ceiling before starting work. And if air conditioning contractors will tell you are simply a system through the existing pipeline and power outlets, many questions have to swap and be careful because they can not help you when you are well paid and the system is not functioning effectively .

In some cases, using the existing network may be an option, but it iswould be less efficient.

Exchange of evaporative air conditioning reverse cycle (HVAC) Air Conditioning - A Complete Guide